[ovs-discuss] Use ovs to create a bridge connect two subnets with different IP ranges

[Justin Pettit]

OVS is a switch and works at layer-2, it sounds like you need a router to work at layer-3.

--Justin


On Dec 3, 2013, at 8:05 AM, WEIYU LIU <weiyu.liu at utah.edu> wrote:

> Hey, all.
> 
> I created a bridge using ovs and attached the two interfaces connected to the two subnets to the bridge. And then these two interfaces can not be reached by other nodes. So I assign the bridge with one of the interfaces' IP address. Then this IP can be reached. But the other still can not work. Did anyone have some suggestions? Thanks a lot.
> 
> Best!
> Weiyu
> _______________________________________________
> discuss mailing list
> discuss at openvswitch.org
> http://openvswitch.org/mailman/listinfo/discuss