[ovs-discuss] Physical Ip Address

Justin Pettit jpettit at nicira.com
Sat Mar 1 00:49:00 UTC 2014


On Feb 28, 2014, at 2:59 PM, filipe Antonio <fantonio at student.dei.uc.pt> wrote:

> I installed an OVS in a PC-Linux. When I add the WNIC to a bridge of
> OVS, it loose IP connectivity with the gateway. I need the LAN devices
> still recognize the IP address of the WNIC of PC-Linux. How can I do that?

I think this FAQ entry will answer your question:

Q: I created a bridge and added my Ethernet port to it, using commands
   like these:

       ovs-vsctl add-br br0
       ovs-vsctl add-port br0 eth0

   and as soon as I ran the "add-port" command I lost all connectivity
   through eth0.  Help!

A: A physical Ethernet device that is part of an Open vSwitch bridge
   should not have an IP address.  If one does, then that IP address
   will not be fully functional.

   You can restore functionality by moving the IP address to an Open
   vSwitch "internal" device, such as the network device named after
   the bridge itself.  For example, assuming that eth0's IP address is
   192.168.128.5, you could run the commands below to fix up the
   situation:

       ifconfig eth0 0.0.0.0
       ifconfig br0 192.168.128.5

   (If your only connection to the machine running OVS is through the
   IP address in question, then you would want to run all of these
   commands on a single command line, or put them into a script.)  If
   there were any additional routes assigned to eth0, then you would
   also want to use commands to adjust these routes to go through br0.

   If you use DHCP to obtain an IP address, then you should kill the
   DHCP client that was listening on the physical Ethernet interface
   (e.g. eth0) and start one listening on the internal interface
   (e.g. br0).  You might still need to manually clear the IP address
   from the physical interface (e.g. with "ifconfig eth0 0.0.0.0").

   There is no compelling reason why Open vSwitch must work this way.
   However, this is the way that the Linux kernel bridge module has
   always worked, so it's a model that those accustomed to Linux
   bridging are already used to.  Also, the model that most people
   expect is not implementable without kernel changes on all the
   versions of Linux that Open vSwitch supports.

   By the way, this issue is not specific to physical Ethernet
   devices.  It applies to all network devices except Open vswitch
   "internal" devices.

Using a wireless NIC can also have some other issues, so if you run into additional problems, I'd recommend looking at the FAQ.

--Justin





More information about the discuss mailing list