[ovs-discuss] [ovs-dev] How to set QoS for VM egress traffic on tunnel mode
Ben Pfaff
blp at ovn.org
Tue Nov 28 18:40:07 UTC 2017
On Wed, Nov 22, 2017 at 09:50:54AM +0000, 王志克 wrote:
> Hi All,
>
> I want to set QoS with guide from below link “egress traffic shaping”, but do not know how for tunnel mode.
> http://docs.openvswitch.org/en/latest/faq/qos/
>
> My scenario:
>
> I have several VM ports, and several VxLan ports in br0, and there is one seprate eth0 port (not in br0), which is the underlay port of Vxlan port.
> Currently I add rule to match VM traffic to certain Vxlan port, and all these vxlan ports would go out through eth0.
>
> Now I want to enable egress traffic shaping, eg:
> VM1 goes out with min_rate=10M, max_rate=100M.
> VM2 goes out with min_rate=50M, max_rate=200M.
>
> In the given example in http://docs.openvswitch.org/en/latest/faq/qos/ chapter “egress traffic shaping”, it directly uses the physical port. But in tunnel case, I can NOT specify the physical port directly.
> So how to configrue egress traffic shaping in tunnel case? Appreciate some example configruation. Thanks.
You would want to configure shaping on the physical output port in this
case.
More information about the discuss
mailing list