[ovs-discuss] bond control syntax
Ben Pfaff
blp at ovn.org
Mon Mar 5 16:58:20 UTC 2018
On Sun, Mar 04, 2018 at 12:34:53PM -0500, Chris Boley wrote:
> Hi,
> I worked on this more and found that this worked. If anyone is actually
> interested.
>
> sudo touch /etc/network/if-up.d/vbond0_tune
> sudo nano /etc/network/if-up.d/vbond0_tune
>
> ##Pasted this in###
>
> ovs-vsctl set port vbond0 other_config:lacp-system-priority=50
> other_config:bond-rebalance-interval=5000 other_config:
> bond-detect-mode=miimon other_config:bond-miimon-interval=100
> other_config:bond_updelay=200 other_config:bond_downdelay=200
> exit
>
> ##save file and exit##
>
> sudo chmod a+x /etc/network/if-up.d/vbond0_tune
>
> modify interfaces file to look this way:
> allow-vbridge0 vbond0
> iface vbond0 inet manual
> ovs_bridge vbridge0
> ovs_type OVSBond
> ovs_bonds eth1 eth2
> ovs_options bond_mode=balance-slb lacp=active
> post-up /etc/network/if-up.d/vbond0_tune
>
> After that I could run:
> foo at VMHOST:~$ sudo ovs-vsctl list port vbond0
>
> And I could see all the "other_options"
>
> The ovs-appctl bond/show vbond0 isn't really reflecting my up and down
> delay. I'm not sure though if that's because the Cisco Switch ports are
> taking priority or what's going on.
bond_updelay and bond_downdelay are columns rather than keys within
other_config, so you should be able to just remove "other_config:" from
those settings to make them work.
More information about the discuss
mailing list